How To Change A Bathroom Faucet

Posted on

How To Change A Bathroom Faucet. You may have to scrape and scour to remove hard water deposits, although depending on the new faucet, some of the area may be covered. Unscrew the metal rim around the drain (the drain collar) from the pipe underneath (the drain rim).

How to Install/Replace a Bathroom Faucet! YouTube
How to Install/Replace a Bathroom Faucet! YouTube from youtube.com

Reach up under the sink, attach the basin or ridgid tool on the supply line nuts, and turn the tool clockwise. Then run hot and cold water for one minute. Then, remove the screw and set it in a safe place.

Before Installing Your New Faucet, Give The Sink A Good Cleaning Where The Old Faucet Was Mounted.

Danny, from the home depot, walks through the installation of a new sink faucet in just. Many bathroom faucet replacement kits include new drains, so take this opportunity to replace the drain pipe. You may have to scrape and scour to remove hard water deposits, although depending on the new faucet, some of the area may be covered.

Match The Tailpipes And Valves With The Proper Holes, And Place The Faucet Into Position.

Also, clean that faucet area with a mixture of white vinegar and water. Hold the faucet in both hands and carefully set it into the mounting holes. Many of these tiny parts of the moen bathroom faucet handle are affordable and easy to get.

To Begin Installing The New Faucet, Center The Spout In The Sink's Middle Hole.

If this is a single handle faucet, turn off both supplies. Try vinegar or an acid cleaner to help dissolve hard water deposits. Turn off the water supply to the faucet.

Lift The Faucet Handle Off Of The Faucet Body, Then Continue With Whatever Repairs You Need To Do.

If that is the case, use your nail or the flathead screwdriver to pry off the cap gently. From below, slide the flat washer. Once the faucet is in the mounting holes, insert a washer.

Use Your Bucket Or Basin To Catch Any Spilling Water.

Unscrew the metal rim around the drain (the drain collar) from the pipe underneath (the drain rim). Find the water source beneath the shelving unit or valve and turn off it. Then run hot and cold water for one minute.

Leave a Reply

Your email address will not be published.